Please Baidu search Chuzhou Tengxin New Material Co., Ltd. to find us!

Stainless steel metal sheet protective film glue

TX-311

Word:[Big][Middle][Small] QR Code 2018-12-26     Viewed:    

TX-311

product description: TX-311
Extra high viscosity emulsion protective film pressure sensitive adhesive
TX-311 is a two-component ultra-high-viscosity paste that does not require peeling off the surface film of stainless steel plates and other surface adhesives, pressure-sensitive adhesives. This product has the advantages of environmental protection, no pollution, non-toxic and tasteless, easy operation, high solid content and so on.
Physical index: Exterior Milky white with green   Visual inspection
Solid content 54±1%   HG∕T 5054-2016 
PH value 7.5~9.0
Rotational viscosity 100~400mpa.s
Glue characteristics: TX-311 is a two-component emulsion pressure-sensitive adhesive. The product has the following characteristics:
1. This product is a special high-viscosity environmentally-friendly emulsion pressure-sensitive adhesive for carpet protective films. It is recommended that the protected surface cover a full range of carpets (wool carpets are recommended to be used with caution), and glass explosion-proof films.
2. High peel strength, moderate viscosity increase effect, good adhesion to carpet fibers and excellent warpage resistance.
3. The protective film has high peel strength, light unwinding force, and the protective film has no tensile deformation.
4. The flatness of the coating surface and excellent transparency. The thickening effect satisfies the application of such films.
Glue operation method: When mixing the glue, TX-311 is mechanically stirred, and the quantitative T-07 additive is slowly added. After the additive is added, it is stirred for 5 minutes to make it evenly dispersed in the glue. The prepared glue is put into the glue tank through an 80 mesh filter, and the undispersed glue block can be filtered out.
Precautions: 1. The safe use period of the configured glue is 7 ~ 8 hours, so the glue needs to be used up within the safe period.
2. The additive T-07 is afraid of moisture, high heat and low temperature, and ultraviolet light, so the storage condition of the additive T-07 should be: dry and ventilated, the temperature is moderate (5 ℃ ~ 30 ℃), and protected from light.
3. Samples need to be tested before the product is used in batches, and then used in batches after passing the test.
Glue storage and transportation: 1. The product is a non-hazardous chemical and is transported as a general liquid to prevent damage to the packaging.
2. The product is stored in a ventilated and dark warehouse, the temperature is not lower than 0 ℃, 5 ~ 30 ℃, and the storage period is 6 months.

Go Back
Print
0550-2203881
浏览手机站